Command Line Reference Guide

Defaults 4 (0x10 in the bitmap)
Command
Modes
PROTOCOL LLDP (only on the global, not on the interface)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
iscsi profile-compellant
Configure the auto-detection of Dell Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is
monitored.
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi
target port command.
Parameters
tcp-
port-2...tcpport
- 16
Enter the tcp-port number of the iSCSI target ports. The
tcp-port-n is the TCP port number or a list of TCP port
numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is 860,
3260.
ip-address (Optional) Enter the ip-address that the iSCSI monitors. The
ip-address specifies the IP address of the iSCSI target.
Defaults 860, 3260
Command
Modes
CONFIGURATION
1462
PMUX Mode of the MXL 10/40GbE Switch I/O Module