Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Example
Dell(conf-mon-sess-2)#show config
!
monitor session 2 type rpm
source fortyGigE 0/60 destination remote-vlan 300 direction rx
source Port-channel 10 destination remote-vlan 300 direction
rx
no disable
Dell#
show monitor session
Display the monitor information of a particular session or all sessions.
Z9000
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor
session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range
is from 0 to 65535.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.0.0 Added support for the RPM / ERPM.
Version 9.0.2.0 Introduced on the S6000.
1200
Port Monitoring