Administrator Guide

Usage
Information
A color map outlines the codepoint mappings to the appropriate color mapping
(green, yellow, red) for the traffic. The system uses this information use to handle
the traffic on the interface based on the traffic priority and places it into the
appropriate shaping queue. You cannot delete a DSCP color map when it is
configured on an interface. If you do, all the DSCP values are set to green (low
drop precedence). To delete the DSCP color map that is being used by one or
more interfaces, remove the DSCP map from each interface.
Example
Dell(conf)#qos dscp-color-map mymap
Related
Commands
qos dscp-color-map— associates the DSCP color map profile with an interface so
that all IP packets received on it is given a color based on that color map
dscp— sets the number of specific DSCP values for color map profile to yellow or
red.
qos dscp-color-policy
Associates the DSCP color map profile with an interface so that all IP packets received on it is given a
color based on that color map.
Syntax
dscp-color-policy color-map-profile-name
To remove a color policy map profile, use the no dscp-color-policy color-
map-profile-name command.
Parameters
color-map-
profile-name
Enter the color map profile name. The name can have a
maximum of 32 characters.
Defaults None
Command
Modes
CONFIG-INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5.0.0 Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage
Information
If the specified color-map does not exist, the Diffserv Manager (DSM) creates a
color map and sets all the DSCP values to green (low drop precedence).
Example
The following example assigns the color map, bat-enclave-map, to interface te
0/11.
Dell(conf)# int te 0/11
Dell(conf-if-te-0/11)# qos dscp-color-policy bat-enclave-map
1274
Quality of Service (QoS)