Reference Guide

pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Set the time interval to a number large enough to prevent unnecessary retransmissions. For
example, the interval must be larger for interfaces connected to virtual links.
ip ospf transmit-delay
To send a link state update packet on the interface, set the estimated time elapsed.
Z9000
Syntax
ip ospf transmit-delay seconds
To return to the default value, use the no ip ospf transmit-delay command.
Parameters
seconds
Enter the number of seconds as the interval between retransmission.
The range is from 1 to 3600. The default is 1 second.
This value must be greater than the transmission and propagation
delays for the interface.
Defaults 1 second
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant
FTOS Command Line Reference Guide
.
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
log-adjacency-changes
To send a Syslog message about changes in the OSPF adjacency state, set FTOS.
Z9000
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes command.
Defaults Disabled.
Command Modes ROUTER OSPF
978