Reference Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Setting a priority of 0 makes the router ineligible for election as a designated router or backup
designated router.
Use this command for interfaces connected to multi-access networks, not point-to-point
networks.
ip ospf retransmit-interval
Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the interface.
Z9000
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the no ip ospf retransmit-interval command.
Parameters
seconds Enter the number of seconds as the interval between retransmission.
The range is from 1 to 3600. The default is 5 seconds.
This interval must be greater than the expected round-trip time for a
packet to travel between two routers.
Defaults 5 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
977