Reference Guide

debug lacp
Debug LACP (configuration, events, and so on).
Z9000
Syntax
debug lacp [config | events | pdu [interface-type [in | out]]]
To disable LACP debugging, use the no [config | events | pdu [interface-
type [in | out]]] command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP
configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP event
information.
pdu (OPTIONAL) Enter the keyword pdu to debug the LACP Protocol Data
Unit information.
interface-type in |
out
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
846