Reference Guide

Capabilities received from neighbor for IPv6 Unicast :
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
Capabilities advertised to neighbor for IPv6 Unicast :
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
For address family: IPv6 Unicast
BGP table version 12, neighbor version 12
2 accepted prefixes consume 32 bytes
Prefix advertised 0, rejected 0, withdrawn 0
Connections established 3; dropped 2
Last reset 00:00:41, due to Closed by neighbor
Notification History
'OPEN error/Bad AS' Sent : 0 Recv: 1
Local host: 5ffe:11::4, Local port: 179
Related
Commands
show ip bgp ipv6 unicast – views the current BGP routing table.
show ip bgp ipv6 unicast peer-group
Allows you to view information on the BGP peers in a peer group.
Z9000
Syntax
show ip bgp ipv6 unicast peer-group [peer-group-name [summary]]
Parameters
peer-group-name (OPTIONAL) Enter the name of a peer group to view information about
that peer group only.
summary (OPTIONAL) Enter the keyword summary to view status information
of the peers in that peer group. The output is the same as that found
in the
show ip bgp ipv6 unicast summary command.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
781