Reference Guide

of-instance{ of-id } Enter the keyword of-instance then the OpenFlow instance ID to add
the VLAN to the specified OpenFlow instance. The range is from 1 to
8.
NOTE: Associate the OpenFlow instance with the VLAN when the
VLAN is created. An existing VLAN cannot be associated with an
OpenFlow instance.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
For more information about VLANs and the commands to configure them, refer to the Virtual
LAN (VLAN) Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. For more information, refer to the Access Control Lists (ACL)
chapter.
The following features are not supported on VLANs associated with an OpenFlow instance:
• IPv4
• IPv6
• MTU
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot be enabled
simultaneously.
Example (Single
Range)
FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#
Related
Commands
interface — configures a physical interface.
interface loopback — configures a loopback interface.
interface null — configures a null interface.
interface port-channel — configures a port channel group.
show vlan — displays the current VLAN configuration on the switch.
shutdown — disables/enables the VLAN.
tagged — adds a Layer 2 interface to a VLAN as a tagged interface.
untagged — adds a Layer 2 interface to a VLAN as an untagged interface.
openflow of-instance — creates or modifies an OpenFlow instance.
509