Reference Guide

The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior releases
supported 2094.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
When creating an interface range, interfaces appear in the order they are entered; they are not
sorted. The command verifies that interfaces are present (physical) or configured (logical).
Important Points to Remember:
• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a warning
message.
• The interface range prompt includes interface types with slot/port information
for valid interfaces. The prompt allows for a maximum of 32 characters. If the bulk
configuration exceeds 32 characters, it is represented by an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest
start port and the biggest end port.
Example (Bulk)
FTOS(conf)#interface range so 2/0-1, te 10/0, gi 3/0, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (Multiple
Ports)
FTOS(conf)#interface range gi 2/0 - 23, gi 2/1 - 10
FTOS(conf-if-range-gi-2/0-23#
Example
(Overlapping
Ports)
FTOS(conf)#interface range gi 2/1 - 11, gi 2/1 - 23
FTOS(conf-if-range-gi-2/1-23#
Usage
Information
Only VLAN and port-channel interfaces created using the interface vlan and
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the
show running-
config command cannot be used with the bulk configuration feature of the interface
range command. You cannot create virtual interfaces (VLAN, Port-channel) using the
interface range command.
505