Reference Guide

Parameters
environment
variable
Enter the environment variable to be saved.
Command Modes grub
Command History
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
The environment variables are listed under the list_env command. You must save the
environment variables before rebooting. The save_env command must be used for each
variable set using the
set command.
Example
grub>save_env primary_boot
grub>
set
Sets the environment variables.
Z9000
Syntax
set [serverip=address | ipaddr=address | netmask=subnet-mask |
gatewayip = address | primary_boot=’f10boot location’ |
secondary_boot=’f10boot location’ | default_boot=’f10boot
location’ | macaddr=mac-address | baudrate=rate |
enablepwdignore | stdconfigignore}
Parameters
serverip Set the IP address of the server.
ipaddr Set the Management IP address of the unit.
netmask Set the subnet mask of the Management IP address.
gatewayip Set the IP address of the gateway.
primary_boot Set the primary boot parameter. The location must be flash0, flash1 or
any valid tftp location. The primary boot parameter must be in the
following syntax:
set primary_boot=’f10boot flash0 | flash1 |
tftp://ip-addr/file’
secondary_boot Set the secondary boot parameter. The location must be flash0, flash1
or any valid tftp location. The secondary boot parameter must be in
the following syntax:
set secondary_boot=’f10boot flash0 | flash1 |
tftp://ip-addr/file’
default_boot Set the default boot parameter. The location must be flash0, flash1 or
any valid tftp location. The default boot parameter must be in the
following syntax:
467