Reference Guide

Version 8.3.11.0 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Related
Commands
show hardware stack-unit — displays the data plane or management plane input and output
statistics of the designated component of the designated stack member.
hardware watchdog
To trigger a reboot and restart the system, set the watchdog timer.
Z9000
Syntax
hardware watchdog
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.0 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Usage
Information
This command enables a hardware watchdog mechanism that automatically reboots an FTOS
switch/ router with a single unresponsive unit. This behavior is a last-resort mechanism
intended to prevent a manual power cycle.
show hardware layer2
Display Layer 2 ACL or eg data for the selected stack member and stack member port-pipe.
Z9000
Syntax
show hardware layer2 {eg-acl | in-acl} stack-unit id port-set
number
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to select
between ingress or egress ACL data.
stack- unit id Enter the keyword stack-unit to select a stack ID. The unit ID
range is 0 for the Z9000.
port-set number Enter the keywords port-set with a port-pipe number. The range
is from 0 or 3 for the Z9000.
.
393