Reference Guide

count: 2, range entries: 2, sequences: 5 - 10
ip prefix-list test2:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test3:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test4:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test5:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test6:
count: 1, range entries: 1, sequences: 5 - 5
FTOS#
Route Map Commands
When you create an access-list without any rule and then applied to an interface, the ACL behavior reflects implicit
permit.
To configure route maps and their redistribution criteria, use the following commands.
continue
To a route-map entry with a higher sequence number, configure a route-map.
Z9000
Syntax
continue [sequence-number]
Parameters
sequence-
number
(OPTIONAL) Enter the route map sequence number. The range is from
1 to 65535.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
215