Reference Guide

Usage
Information
When you use the log option, the CP processor logs details about the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets’ details.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to forward packets.
IP Prefix List Commands
When you create an access-list without any rule and then apply it to an interface, the ACL behavior reflects implicit
permit.
To configure or enable IP prefix lists, use these commands.
clear ip prefix-list
Reset the number of times traffic mets the conditions (“hit” counters) of the configured prefix lists.
Z9000
Syntax
clear ip prefix-list [prefix-name]
Parameters
prefix-name (OPTIONAL) Enter the name of the configured prefix list to clear only
counters for that prefix list, up to 140 characters long.
Defaults Clears “hit” counters for all prefix lists unless a prefix list is specified.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increase the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
208