Reference Guide

• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
• track
• virtual-address
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group. The range is
from 1 to 255.
vrf instance (OPTIONAL) E-Series only: Enter the name of a VRF instance (32
characters maximum) to clear the counters of all IPv6 VRRP groups in
the specified VRF.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.10.0 Introduced on the S4810.
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support
was added for IPv6 VRRP groups in non-default VRF instances.
Version 8.3.2.0 Introduced on the E-Series TeraScale.
debug vrrp ipv6
Allows you to enable debugging of VRRP.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state |
timer}
1457