Reference Guide

Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
If you have configured a tunnel interface or destination address, the tunnel source must be
compatible for this command to function. If you configure the tunnel source address as an
interface, the tunnel does not function unless a compatible address is present on the specified
interface.
If you configure the tunnel source address as tunnel source interface, the lowest
address is used. This address is not changed even if you configure a lower address on the
selected interface. To change the selected address, reload or recreate the tunnel or remove
the selected address from the interface.
1411