Reference Guide

pre-Version
6.2.1.0
Introduced on the E-Series.
radius-server deadtime
Configure a time interval during which non-responsive RADIUS servers to authentication requests are skipped.
Z9000
Syntax
radius-server deadtime seconds
To disable this function or return to the default value, use the no radius-server
deadtime command.
Parameters
seconds Enter a number of seconds during which non-responsive RADIUS
servers are skipped. The range is from 0 to 2147483647 seconds. The
default is 0 seconds.
Defaults 0 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
radius-server host
Configure a RADIUS server host.
Z9000
Syntax
radius-server host {hostname | ipv4-address | ipv6-address}
[auth-port port-number] [retransmit retries] [timeout seconds]
[key [encryption-type] key]
Parameters
hostname Enter the name of the RADIUS server host.
ipv4-address |
ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of the
RADIUS server host.
1246