Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 Z9000

1171

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 7.8.1.0 Introduced on the S-Series.

Version 7.6.1.0 Introduced on the C-Series.

pre-Version

6.2.1.1

Introduced on the E-Series.

Usage

Information

To enable the interface to send both version of RIP packets, use the ip rip send

version 1 2 command.

Commands

ip rip receive version — sets the RIP version for the interface to receive traffic.

version — sets the RIP version for the switch software.

ip split-horizon

Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any

routes learned over a specific interface to be sent back out that interface.

Z9000

Syntax

ip split-horizon

To disable split-horizon, use the no ip split-horizon command.

Defaults Enabled

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, refer to the

relevant

FTOS Command Line Reference Guide

The following is a list of the FTOS version history for this command.