Reference Guide
39
Routing Information Protocol (RIP)
Routing information protocol (RIP) is a distance vector routing protocol. The Dell Networking operating software (FTOS)
supports both RIP version 1 (RIPv1) and RIP version 2 (RIPv2) on the Z9000 platform.
The FTOS implementation of RIP is based on IETF RFCs 2453 and RFC 1058. For more information about configuring RIP,
refer to the
FTOS Configuration Guide
.
auto-summary
Restore the default behavior of automatic summarization of subnet routes into network routes. This command applies
only to RIP version 2.
Z9000
Syntax
auto-summary
To send sub-prefix routing information, use the no auto-summary command.
Defaults Enabled.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant
FTOS Command Line Reference Guide
.
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
1165