Reference Guide

Version 8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
Version 7.6.1.0 Introduced on the S-Series and C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
On 40-port 10G linecards, if the traffic is shaped between 64 and 1000 Kbs, for some values, the
shaped rate is much less than the value configured. Do not use values in this range for 10G
interfaces.
Related
Commands
rate-shape — shapes traffic output as part of the designated policy.
service-class bandwidth-percentage
Specify a minimum bandwidth for queues.
Z9000
Syntax
service-class bandwidth-percentage queue0 number queue1 number
queue2 number queue3 number
Parameters
number Enter the bandwidth-weight, as a percentage. The value must be a
power of 2. The range is from 1 to 1024.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Guarantee a minimum bandwidth to different queues globally using the service-class
bandwidth-weight command from CONFIGURATION mode. The command is applied in
the same way as the bandwidth-weight command in an output QoS policy. The
bandwidth-weight command in QOS-POLICY-OUT mode supersedes the service-
class bandwidth-weight command.
service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
Z9000
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value |
dot1p2 value | dot1p3 value | dot1p4 value| dot1p5 value |
dot1p6 value | dot1p7 value}
1121