Reference Guide

The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
Related
Commands
telnet — telnets to another device.
ip tftp source-interface
Assign an interface’s IP address in outgoing packets for TFTP traffic.
Z9000
Syntax
ip tftp source-interface interface
To return to the default setting, use the no ip tftp source-interface interface
command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword loopback then
a number from zero (0) to 16383.
• For a Port Channel, enter the keyword port-channel then
a number. For the C-Series and S-Series, the range is 1 to 128.
• For the SONET interfaces, enter the keyword sonet then
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a number
from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing
packets.
100