Laptop User Manual

1444 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Configuring a utilization list for an uplink port
A
NOTE
The example above represents a pure configuration in which traffic is exchanged only by ports 1/2
and 1/1, and by ports 1/3 and 1/1. For this reason, the percentages for the two downlink ports
equal 100%. In some cases, the percentages do not always equal 100%. This is true in cases where
the ports exchange some traffic with other ports in the system or when the downlink ports are
configured together in a port-based VLAN.
In the following example, ports 1/2 and 1/3 are in the same port-based VLAN.
PowerConnect#show relative-utilization 1
uplink: ethe 1
30-sec total uplink packet count = 3011
packet count ratio (%)
1/ 2:100 1/ 3:100
Here is another example showing different data for the same link utilization list. In this example,
port 1/2 is connected to a hub and is sending traffic to port 1/1. Port 1/3 is unconnected.
PowerConnect#show relative-utilization 1
uplink: ethe 1
30-sec total uplink packet count = 2996
packet count ratio (%)
1 /2:100 1/ 3:---