Administrator Guide

• Promote the replica set to a recovery volume (and snapshots) on the secondary group and congure initiators to connect to the
recovery volume.
If the primary group becomes available, you can replicate the recovery volume to the primary group and then fail back to the
primary group, returning to the original conguration.
NOTE: Replication is used primarily for disaster recovery and does not take the place of a comprehensive backup
strategy.
You can manually delete replicas and replica sets that are no longer needed. You cannot delete the most recent, complete replica
from a replica set, but you can delete the entire replica set, which disables replication on the volume.
NOTE: For information about NAS replication options, refer to NAS Volume Replication Operations.
Replication Types
PS Series rmware provides the following methods for automatically replicating block volumes to provide protection against
accidental data loss:
• Traditional replication (often referred to as Replication or Auto-Replication) is a point-in-time process that is conducted between
two groups, often in geographically diverse locations. Replication provides protection against a regional disaster such as an
earthquake or hurricane.
• Synchronous replication (also known as SyncRep) is a real-time process that simultaneously writes volume data across two
dierent pools within the same PS Series group. This method is useful for maintaining two copies of a volume’s data in the same
data center, or dispersed to two dierent facilities on the same campus or in the same metropolitan area.
NOTE: You cannot enable synchronous replication on a volume for which traditional replication is congured, and you
cannot enable traditional replication on a volume for which synchronous replication is congured.
In addition to these two replication methods, the Dell Fluid File System (FluidFS) release available on FS7500 and FS76x0 series NAS
appliances allows you to replicate NAS containers between EqualLogic NAS clusters. This point-in-time NAS replication uses space-
ecient snapshots of NAS containers to replicate le data. You can manage both block and NAS replication using the Group
Manager interface.
NOTE: Throughout the rmware documentation, generic references to replication always refer to traditional replication.
A third type of replication, called manual transfer replication, accommodates less common instances where the network link between
groups might be insucient to support large data transfers. This method is typically done as a precursor to enacting traditional
replication, so the initial full-volume transfers do not have to be done over the network. Manual transfer replication involves copying
the data to external media, then physically transferring it and recopying it to the other member. See the Dell EqualLogic Manual
Transfer Utility Installation and User’s Guide for more information.
Plan Your Volume Replication Environment
To help ensure successful replication, for each volume that you want to replicate follow these steps to set up your replication
environment:
1. Gather the following information to help you determine how much replication space you need:
• Number of replicas you want to keep
• Average time span between each consecutive replica
• Reported size of the volume
• Whether thin-provisioned or not
• Estimated rate of volume changes (depends on volume usage)
2. Make sure that the primary group has enough free pool space for the local replication reserve for each replicated volume.
3. Identify a replication partner (secondary group) to store the volume replicas. This secondary group must meet the space and
network connectivity requirements.
4. Verify on the primary group that the secondary group is congured as a replication partner.
5. Verify on the secondary group:
About Backing Up and Protecting Your Data
245