Owners Manual

PS6000 Hardware Maintenance Maintaining Disks
2–8
Figure 2-7: Closing the Disk Handle
Verify that the new disk is operational by examining the LEDs on the front panel,
as described in Interpreting Disk LEDs on page 2-2.
In addition, the GUI Member Disks window and the CLI
member select show
disks
command output should show that the new disk is operational.
Installing the Bezel
After you install all the replacement disks or blanks, re-install and lock the bezel.
1. Facing the front of the array, fit the right side of the bezel into the right side of
the chassis.
2. Push the bezel toward the chassis until the left side of the bezel engages with
the chassis.
3. Insert the bezel key and turn it counter-clockwise to lock the bezel.
4. Store the key in a safe place.