Owners Manual

Figure 76. Installing the system board
Next steps
1. Replace the following:
a. Trusted Platform Module
b. Integrated storage controller card
c. USB 3.0 module (if applicable)
d. All expansion cards and risers
e. Processors and heat sink modules
f. Memory modules and memory module blanks
g. Network daughter card
h. Air shroud
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Follow the procedures in After working inside your system.
4. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag. For more information, see Restoring the Service Tag by using
the Easy Restore feature.
b. If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see
Restoring the Service Tag by using the Easy Restore feature.
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see Upgrading the Trusted Platform Module.
5. Import your new or existing iDRAC Enterprise license.
For more information, see iDRAC User's Guide, at Dell.com/idracmanuals.
Entering the system Service Tag using System Setup
If Easy Restore fails to restore the Service Tag, use System Setup to enter the Service Tag.
Steps
1. Turn on the system.
110
Installing and removing system components