Owners Manual

2. Using Phillips #1 screwdriver, remove the screws on the USB module.
3. Slide the module out of the system until it is free of the USB module slot on the front panel.
Figure 67. Removing the USB module
Next steps
Install the USB module.
Installing the USB module
Prerequisites
Follow the safety guidelines listed in Safety instructions.
NOTE: The procedure to install the USB 3.0 and USB 2.0 modules is similar.
Steps
1. Route the USB cable on the USB module, through the USB slot on the front panel.
2. Insert the USB module into the slot on the front panel.
3. Align the screw on the module with the screw hole on the system.
4. Use a Phillips #1 screwdriver to tighten the screw and secure the module to the system.
5. Route the USB cable and connect it to the USB connector on the system board. For more information, see System board
jumpers and connecters.
Installing and removing system components
101