CLI Guide

Layer 2 Switching Commands 792
thresholds for buffering on the port are reached. A conscientious network
operator might want to examine why the devices attached to Gi1/0/5 and
Gi1/0/6 are sending so much traffic to Gi1/0/2 attached devices and either re-
distribute the devices, rate-limit traffic egressing the devices attached to
Gi1/0/5 and Gi1/0/6, or increase the number of links available for the device
attached to Gi1/0/2.
console#show interfaces utilization
Port Load Oper. Rx Tx Rx Tx Buffer Drop
Interval Speed Util Util PPS PPS Size Count
--------- -------- ------ ----- ----- ------- -------- -------- ---------
Gi1/0/1 300 10M 1 0 296 0 0 0
Gi1/0/2 300 1G 0 99 0 674500 938098 1102
Gi1/0/3 300 1G 0 15 0 112428 7 0
Gi1/0/4 300 0 0 0 0 1 0 0
Gi1/0/5 300 1G 37 0 249565 1 0 1
Gi1/0/6 300 1G 88 1 593560 3 0 0
Gi1/0/7 300 0 0 0 0 0 0 0
Gi1/0/8 300 0 0 0 0 1 0 0
show policy-map
Use the show policy-map command to display all configuration information
for the specified policy.
NOTE: This command is not available on the N1500 Series switches.
Syntax
show policy-map [policyname]
• policyname — Specifies the name of a valid existing DiffServ policy.
(Range: 1-31)
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes