CLI Guide

Layer 2 Switching Commands 777
Class Name Type ACL Identifier or Reference Class Name
------------------------------- ----- --------------------------------------
cee All acl (IP )
ipv4 All
stop_http_class Any
console#show class-map ipv4
Class Name..................................... ipv4
Class Type..................................... All
Match Rule Count............................... 1
Match Criteria Values
---------------------------- --------------------------------------------
Source IP Address 2.2.2.2 (255.255.255.0)
console#show class-map stop_http_class
Class Name..................................... stop_http_class
Class Type..................................... Any
Match Rule Count............................... 2
Match Criteria Values
---------------------------- --------------------------------------------
Source IP Address 2001:db8::/32
Source Layer 4 Port 80(http/www)
show classofservice dot1p-mapping
Use the show classofservice dot1p-mapping command to display the current
IEEE 802.1p priority mapping to internal traffic classes for a specific
interface.
Syntax
show classofservice dot1p-mapping [{gigabitethernet unit/slot/port | port-
channel port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}]
Default Configuration
By default, interfaces are configured to trust the IEEE 802.1p value in
received packets and utilize the dot1p-mapping to assign packets to CoS
queues.