CLI Guide

Layer 2 Switching Commands 618
no lldp transmit
Default Configuration
LLDP is enabled on all supported interfaces.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how enable the transmission of local data.
console(config-if-Gi1/0/3)#lldp transmit
lldp tlv-select
Use the lldp tlv-select command to specify which optional type-length-value
settings (TLVs) in the 802.3 AB basic management set will be transmitted in
the LLDPDUs. To disable transmission of an optional TLV, use the no form
of this command. To return the configuration to the default, use the no form
of the command with no arguments.
Syntax
lldp tlv-select [management-address][port-description][port-vlan][
system-capabilities][system-description][system-name]
no lldp tlv-select [management-address][port-description][port-
vlan][system-capabilities][system-description][system-name]
• management-address— Transmits the switch management address (TLV
type 8).
• port-description — Transmits the port description (TLV type 4).
• port-vlan — Transmits the port PVID (TLV type 127, subtype 1)
• system-name — Transmits the system name (TLV type 5).
• system-description — Transmits the system description (TLV type 6).