CLI Guide

Layer 2 Switching Commands 606
no depends-on intf-list
• intf-list — List of Ethernet interface identifiers or port channel interface
identifiers or ranges.Separate nonconsecutive items with a comma and no
spaces. Use a hyphen to designate the range of ports or port-channel
numbers.
Default Configuration
This command has no default configuration.
Command Mode
Link Dependency mode
User Guidelines
Circular dependencies are not allowed, i.e. interfaces added to the group may
not also appear in the depends-on list of the same group or a different group.
If an interface appears in the add list of any group, the interfaces in the
corresponding depends-on list may not refer back to the interfaces in the add
group.
Examples
console(config-linkDep-group-1)#depends-on gigabitethernet 1/0/10
console(config-linkDep-group-1)#depends-on port-channel 6
show link-dependency
Use the show link-dependency command to show the link dependencies
configured for a particular group. If no group is specified, then all the
configured link-dependency groups are displayed.
Syntax
show link-dependency [group GroupId] [detail]
• GroupID—Link dependency group identifier. (Range: Valid Group Id, 1–
16)
• detail—Show detailed information about the state of members and the
dependent ports.