CLI Guide

Switch Management Commands 2141
Default Configuration
DHCP server packet tracing is disabled by default.
Command Mode
Privileged Exec
User Guidelines
The DHCP server support an internal packet tracing facility. This command
turns the packet tracing on.
Debug commands should be used with caution. Switch behavior may be
adversely affected by the additional processing load incurred by enabling
debug output.
Example
This example enables DHCP server packet tracing.
console#debug dhcp server packet
debug dot1x
Use the debug dot1x command to enable dot1x packet tracing. Use the “no”
form of this command to disable dot1x packet tracing.
Syntax
debug dot1x packet [receive | transmit]
no debug dot1x packet [receive | transmit]
Default Configuration
Display of dot1x traces is disabled by default.
Command Mode
Privileged Exec mode.