CLI Guide

Switch Management Commands 1999
Syntax
client-name name
no client-name
• name—The name of the DHCP client. The client name is specified as up
to 31 printable characters.
Default Configuration
There is no default client name.
Command Mode
DHCP Pool Configuration mode
User Guidelines
Use the show ip dhcp pool command to display pool configuration
parameters. The client name should not include the domain name as it is
specified separately by the domain-name (IP DHCP Pool Config) command. It
is not recommended to use embedded blanks in client names.
Question marks are not allowed in the client name. Enclose the client name
in quotes if a blank appears in the name.
Example
console(config-dhcp-pool)#client-identifier 01:03:13:18:22:33:11
console(config-dhcp-pool)#host 192.168.21.34 32
console(config-dhcp-pool)#client-name Line_Printer_Hallway
default-router
Use the default-router command in DHCP Pool Configuration mode to set
the IPv4 address of one or more routers for the DHCP client to use. Use the
no form of the command to remove the default router configuration. Use the
show ip dhcp pool command to display pool configuration parameters.
Syntax
default-router {ip-address1}[ip address2]
no default-router