CLI Guide

Layer 3 Routing Commands 1904
V3 Down 222
Track Route(pfx/len) Reachable Decrement-Priority
--------------------- --------- ------------------
14.14.14.0/24 True 14
accept-mode
Use this command to control whether a virtual router in master state will
accept packets addressed to the address owner’s Virtual IP address as its own
if it is not the Virtual IP address owner. By default this mode is disabled. To
disable this function, use the no form of this command.
Syntax
accept-mode
no accept-mode
Default Configuration
This command is disabled by default.
Command Mode
VRRPv3 Group Configuration mode
User Guidelines
This command has no user guidelines.
Command History
Command introduced in version 6.6 firmware.
Example
The following example shows how to enable accept-mode:
console(config-if-vrrp)#accept-mode