CLI Guide

Layer 3 Routing Commands 1417
AS Path.................................... 18 50 27
Origin..................................... Incomplete
Type....................................... External
IGP Cost................................... 10
Peer (Peer ID)............................. 200.1.1.1 (18.24.1.3)
BGP Next Hop............................... 200.1.1.1
Extended Community......................... RT:3:300
template peer
Use the template peer command in router configuration mode to create a
BGP peer template and enter peer template configuration mode. To delete a
peer template, use the no form of this command.
Syntax
template peer name
no template peer name
• name—The name of the template. The name may be no more than 32
characters.
Default Configuration
No peer templates are configured by default.
Command Mode
BGP Router Configuration mode
User Guidelines
A peer template can be configured with parameters that apply to many peers.
Neighbors can then be configured to inherit parameters from the peer
template. A peer template can include both session parameters and peer
policies. Peer policies are configured within an address family configuration
mode and apply only to that address family. You can configure up to 32 peer
templates. When changing a template, the change is immediately applied to
all neighbors that inherit from the template (though policy changes are
subject to a three-minute delay.)
The following commands can be issued in peer template configuration mode
and thus added to a peer template: