CLI Guide

Layer 3 Routing Commands 1338
User Guidelines
When a neighbor is shut down, BGP first sends a NOTIFICATION message
with a Cease error code. When an adjacency is administratively shut down,
the adjacency stays down until administratively re-enabled (using no
neighbor shutdown).
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console(config-router)#neighbor 10.130.14.55 shutdown
neighbor timers
Use the neighbor timers command to override the global keepalive and hold
timer values as well as set the keepalive and hold timers for a specific
neighbor.
Syntax
neighbor { ip-address | ipv6-address [ interface vlan vlan-id ] | autodetect
interface interface-id } timers keepalive holdtime
no neighbor { ip-address | ipv6-address [ interface vlan vlan-id ] | autodetect
interface interface-id } timers
• ip-address—The neighbor’s IPv4 address. This is the IP address of the
neighbor on the connected link.
• ipv6-address—The neighbor’s IPv6 address. If the neighbor’s IPv6 address
is a link local address, the local interface must also be specified.
• interface vlan vlan-id—The local interface/VLAN ID over which the IPv6
neighbor can be reached. Range 1-4093.
• autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface. Range is 1–4093.