Users Guide

752 Access Control Lists
continued • flag [ +fin | -fin ] [ +syn | -syn ] [ +rst | -rst ] [ +psh | -
psh ] [ +ack | -ack ] [ +urg | -urg ] [ established ]—
Specifies that the IP/TCP/UDP ACL rule matches on the
TCP flags.
– Ack – Acknowledgement bit
– Fin – Finished bit
– Psh – push bit
– Rst – reset bit
– Syn – Synchronize bit
– Urg – Urgent bit
– When “+<tcpflagname>
” is specified, a match occurs
if specified <tcpflagname> flag is set in the TCP
header.
– When “-<tcpflagname>
” is specified, a match occurs
if specified <tcpflagname> flag is *NOT* set in the
TCP header.
– When established is specified, a match occurs if either
the RST or ACK bits are set in the TCP header.
– This option is visible only if protocol is tcp.
• [ icmp-type
icmp-type [ icmp-code icmp-code ] | icmp-
message
icmp-message ] — Specifies a match condition
for ICMP packets.
– When icmp-type is specified, IP ACL rule matches on
the specified ICMP message type, a number from 0
to 255.
– When icmp-code is specified, IP ACL rule matches on
the specified ICMP message code, a number from 0
to 255.
– Specifying icmp-message implies both icmp-type and
icmp-code are specified.
– icmp-message is decoded into corresponding ICMP
type and ICMP code within that ICMP type. This
option is visible only if the protocol is icmp.
– IPv4 ICMP message types: echo, echo-reply, host-
redirect, mobile-redirect, net-redirect, net-unreachable,
redirect, packet-too-big, port-unreachable, source-
quench, router-solicitation, router-advertisement, time-
exceeded, ttl-exceeded, unreachable.
Command Purpose