Owner`s manual

9. Remove the tape securing the keyboard cable from the keyboard.
10. Disconnect and remove the keyboard cable from the keyboard.
Installing The Keyboard
1. Connect the keyboard cable and secure it to the keyboard using the tape.
2. Connect the keyboard cable to its connector on the system board.
3. Turn the keyboard over and lay it on the palmrest.
4. Replace and tighten the screws to secure the keyboard to the palmrest
assembly.
5. Replace and tighten the screws to secure the keyboard to the computer.
6. Install the battery .
7. Install the
keyboard trim
8. Follow the procedures in After Working Inside Your Computer .
41