White Papers

22 Setting Up the Dell™ DR Series System as an NFS Target on Amanda Enterprise 3.3.5
4.2 Defining where to restore
The Run Restore process is the last step in the recovery process. In the Run Restore page, you can review
the restore options you have specified, start the actual restore process, and monitor progress.
Note: Only one restore process can be performed for a backup set in the zmanda Management Console.
1. On the Restore tab, click where.
The Restore From, Restore To, and Tapes Needed panels provide information about the restore
job. Make sure the required tapes are in the tape changer (in the slots reserved for the backup set)
if the restore is from a tape.
2. Enter information for the Destination Host Name, Destination Location, and select the other
restore settings and then click Next.
Note: The destination hostname can be a remote machine. The prerequisite for the remote
machine is to install the zmanda client software.