Command Line Interface Guide

name=value pair 1
config=
name=value pair 2 Description
teamednic1nic2: Enables NIC teaming functionality.
dracnic: Enables DRAC NIC if DRAC 5 is installed.
NOTE: The nicselection option is supported only
on PowerEdge 9G to 11G systems. From
PowerEdge 12G systems onwards, primarynw
and failovernw replaces nicselection.
primarynw=dedicated | lom1 | lom2 |
lom3 | lom4
dedicated: Configures dedicated port as primary
network for remote access.
NOTE: This option requires license to configure
primarynw as dedicated. If the appropriate
license is not installed or has expired, the system
displays an error message. For more information,
see Dell License Manager at dell.com/
openmanagemanuals.
lom 1: Configures lom1 port as the primary network for
remote access.
lom 2: Configures lom2 port as the primary network for
remote access.
lom 3: Configures lom3 port as the primary network for
remote access.
lom 4: Configures lom4 port as the primary network for
remote access.
NOTE: The primarynw option is supported from
PowerEdge12G systems onward. If the
primarynw is set to dedicated, then set
failovernw to none.
failovernw=none | lom1 | lom2 | lom3 |
lom4 | all
none: Configures the failover network to none.
lom 1:Configures the failover network to lom 1.
lom 2: Configures the failover network to lom 2.
lom 3: Configures the failover network to lom 3.
lom 4: Configures the failover network to lom 4.
all: Configures the failover network to all loms.
NOTE: The failovernw option is supported on
PowerEdge12G systems onward. Configure both
primarynw and failovernw to set the nicselection.
The primarynw and failovernw options cannot
have the same value.
NOTE: Failovernw requires license to configure
the ports. If the appropriate license is not
installed or has expired, the system displays an
error message. For more information, see Dell
License Manager at dell.com/
openmanagemanuals.
ipaddress=IP
Sets the IP address if you have selected static as the
IP address source for the BMC LAN interface.
subnet=Subnet Sets a subnet mask if you have selected static as the
IP address source for the BMC LAN interface.
89