Command Line Interface Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
attribute=NodeInterleave
NOTE: Use NodeInterleave
instead of numa as numa will
be deprecated in future releases.
setting=enabled | disabled
• enabled: Enables Node
Interleaving and disables
Non-Uniform Memory Access.
• disabled: Disables Node
Interleaving and enables Non-
Uniform Memory Access.
attribute=ppaddress setting=off | lpt1 | lpt2 | lpt3
• off: Disables the parallel port
address.
• lpt1: Locates the device on
LPT1.
• lpt2: Locates the device on
LPT2.
• lpt3: Locates the device on
LPT3.
attribute=ppmode setting=at | ps2 | ecp | epp
• at: Sets the parallel port mode
to AT.
• ps2: Sets the parallel port
mode to PS/2.
• ecp: Sets the parallel port
mode to ECP (extended
capabilities port).
• epp: Sets the parallel port
mode to EPP (enhanced
parallel port).
attribute=primaryscsi setting=on | off force=true
CAUTION: If you modify the
setting for primary scsi, romb,
romba, or rombb, the system
becomes inoperable until you
reinstall the operating system.
• on: Enables this device.
• off: Disables this device.
• force=true: Verification of
setting change.
attribute=romb setting=raid | off | scsi force=true
• raid: Instructs the BIOS to
detect RAID-on-motherboard
as a RAID device.
• off: Disables RAID-on-
motherboard during system
boot.
• scsi:Instructs the BIOS to
detect the RAID-on-
motherboard device as a SCSI
device.
• force=true: Verification of
setting change.
71