Command Line Interface Guide

230 omconfig storage Commands
Example Syntax
To fast initialize virtual disk 4 on controller 1, type:
omconfig storage vdisk action=fastinit controller=1
vdisk=4
omconfig Slow Initialize Virtualize Disk
Use the following omconfig command syntax to slow initialize a virtual disk.
CAUTION: You may receive a warning message if you attempt to delete the
system or boot partition. However, this warning message is not generated always.
Ensure that you do not delete the system or boot partition or other vital data when
using this command.
Complete Syntax
omconfig storage vdisk action=slowinit controller=
id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport
command. To obtain these values, type omreport storage controller to display
the controller IDs and then type omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
In some circumstances, you may receive a warning message if this command
deletes the system or boot partition. You can override this warning by using
the force=yes parameter. In this case, the syntax is as follows:
omconfig storage vdisk action=slowinit controller=
id vdisk=id force=yes
Example Syntax
To slow initialize virtual disk 4 on controller 1, type:
omconfig storage vdisk action=slowinit controller=
1 vdisk=4