Command Line Interface Guide

178 omconfig system or servermodule assetinfo: Editing Cost of Ownership Values
Example Command for Adding Lease Information
To provide a value for a lease parameter, type a command of the form:
omconfig system assetinfo info=lease <name=value pair 2> or
omconfig servermodule assetinfo info=lease <name=value pair 2>.
For example, type:
omconfig system assetinfo info=lease value=4500
or
omconfig servermodule assetinfo info=lease value=
4500
The following message is displayed:
Asset information set successfully.
You can type more than one omconfig system assetinfo or omconfig
servermodule assetinfo command at the same time, as long as all the
parameters for name=value pair 2 belong to the same name=value pair 1.
For an example, see "Example Commands for Adding Acquisition
Information" on page 173.
Adding Maintenance Information
Maintenance refers to activities required to keep the system in good working
order. Table 5-6 shows the valid parameters for adding maintenance
information.
Table 5-6. omconfig system assetinfo info=maintenance or omconfig servermodule
assetinfo info=maintenance
Command
Level 1
Command
Level 2
Command
Level 3
Name= Value
Pair 1
Name= Value
Pair 2
Description
omconfig
system or
servermodule
assetinfo
info=
maintenance
enddate=
<enddate>
Date the extended
warranty agreement
ends.