User's Manual

omconfig: Managing Components Using the Instrumentation Service 139
Commands for Clearing Logs
NOTE: For more information about alert messages, see the Dell OpenManage
Server Administrator Messages Reference Guide.
You can use the omconfig system or omconfig servermodule command to
clear three logs: the alert log, the command log, and the hardware or ESM log.
To clear the contents of the alert log, type:
omconfig system alertlog action=clear
or
omconfig servermodule alertlog action=clear
NOTE: Entering an invalid RAC user name may prevent the command log from
displaying. Clearing the command log resolves this condition.
To clear the contents of the command log, type:
omconfig system cmdlog action=clear
or
omconfig servermodule cmdlog action=clear
To clear the contents of the ESM log, type:
omconfig system esmlog action=clear
or
omconfig servermodule esmlog action=clear
omconfig system pedestinations/omconfig servermodule pedestinations
Use the omconfig system pedestinations or omconfig servermodule
pedestinations command to set IP addresses for alert destinations.
Table 4-23 shows the valid parameters for the command.
NOTE: You can either specify the index and IP address as parameters together or
you can set the only community string as a parameter.
NOTE: Index 1 to 4 accepts an IPv4 address and index 5 to 8 accepts an IPv6
address.