User's Manual

38 omreport: Viewing System Status Using the Instrumentation Service
omreport chassis bmc/omreport mainsystem bmc
This command is phased-out in this releases. It is replaced by the command
"omreport chassis remoteaccess/omreport mainsystem remoteaccess" on
page 50.
omreport chassis currents/omreport mainsystem currents
This command is no longer available through Server Administrator.
RAID Channel A Displays whether RAID-on-motherboard Channel A is detected as a
RAID device or a SCSI device.
RAID Channel B Displays whether RAID-on-motherboard Channel B is detected as a
RAID device or a SCSI device.
SATA Displays whether the onboard SATA controller is set to ATA mode,
RAID mode, or is disabled.
SATA port Displays if the SATA port is enabled or disabled.
Secondary SCSI Displays whether the device is enabled or disabled.
Serial Communications Displays whether COM port 1 and COM port 2 are off or on with or
without console redirection.
Serial Port 1 Displays whether serial port 1 is mapped to a COM port, a
COM port 1, a COM port 3, a COM1 BMC, a BMC Serial, a BMC
NIC, a BMC RAC, or is disabled.
Serial Port 2 Displays whether serial port 2 is mapped to a COM port, a
COM port 2, a COM port 4, or is disabled.
Speaker Displays whether the speaker is on or off.
Trusted Platform Module Displays whether Trusted Platform Module is off, on with pre-boot
measurements, or on without pre-boot measurements
USB or USBB Displays whether the USB port is enabled or disabled.
User accessible USB Displays whether the user-accessible USB port is enabled or
disabled.
Operating System
Watc h dog Tim er
Displays whether the operating system watchdog timer is enable
or disabled.
Table 3-3. BIOS Setup Parameters (continued)
Parameters Description