User's Manual

Table 5. Expected translations.
Client location Service Tag location Does Dell
Management Plug-in
support client
locale?
Can Dell
Management Plug-in
show pages in client
locale language?
Dell Management
Plug-in shows pages
in default English
1 Location A Location A Yes Yes No
2 Location A Location B No No Yes
3 Location A Location B Yes No Yes
4 Location A Location B Yes No Yes
5 Location A Location A No No Yes
Use this following example.
Table 6. Example
Client location Service Tag location Does Dell
Management Plug-in
support client
locale?
Can Dell
Management Plug-in
show pages in client
locale language?
Dell Management
Plug-in shows pages
in default English
1 France France Yes Yes No
2 Brazil China No No Yes
3 Germany China Yes No Yes
4 China Brazil Yes No Yes
5 India India No No Yes
How come I do not see my new iDRAC version details listed on the vCenter Hosts &
Clusters page?
After the successful completion of a firmware update task in the VMware vShpere client’s recent tasks pane, refresh
the Firmware Update page and verify the firmware versions. If the page shows the old versions, then go to Host
Compliance page in Dell Management Center and check the CISOR status of that host. If CISOR is not enabled, then
enable CISOR and reboot host. If the CISOR was already enabled, then login to the iDRAC console, reset iDRAC, wait for
few minutes, and then refresh the Firmware Update page in VMware vSphere client.
How Do I Test Event Settings By Using OMSA To Simulate A Temperature Hardware
Fault?
To make sure that events are functioning correctly:
1. Navigate to Alert Management → Platform Events in the OMSA user interface.
2. Select the Enable Platform Event Filter Alerts check box.
3. Scroll down to the bottom, and click Apply Changes.
4. To make sure that a specific event is enabled, such as temperature warning, select Main System Chassis from the
tree view on the left.
5. Select Temperatures under Main System Chassis.
6. Select the Alert Management tab, and select Temperature Probe Warning.
7. Select the Broadcast a Message check box, and select Apply Changes.
88