User's Manual

Troubleshooting and Frequently Asked Questions 115
The restore operation which
was initiated from USC
completed with errors. For
more information, refer
RAC log.
The RAC log contains the names of the components
that failed during restore. Verify the firmware
information and retry.
Initiating restore failed.
Retry restore operation after
sometime.
Perform A/C power cycle and retry.
An error occurred. Could
not validate the image on
vFlash SD card.
Use a valid backup image and retry.
This operation cannot be
completed. Licensed SD
Card is not present in the
system.
Install the licensed vFlash SD card and retry the
operation.
There is not enough space
on vFlash to perform this
operation. It needs at least
384 MB of available space.
Delete the existing partitions and unwanted files, so
that 384 MB of free space is available.
This operation cannot be
completed because the SD
Card is not present. Insert
the SD card and retry.
Install the licensed vFlash SD card and retry the
operation.
This operation cannot be
completed because one or
more partitions are locked.
Unlock the partition and
retry.
Use the iDRAC vFLash SD card wizard to unlock the
partitions, and retry the operation.
This operation cannot be
completed because one or
more partitions are in use.
Retry after waiting a few
minutes.
Complete the other operations that are using the
partitions, and retry the operation.
Table 5-3. USC-LCE Error Messages and Resolutions (continued)
Error Message Resolution