User's Manual

206 Using the CMC Web Interface
To view whether FlexAddress is active for the chassis:
1
Log in to the Web interface (see "Accessing the CMC Web Interface" on
page 103).
2 Click Chassis Overview in the system tree.
3 Click the Setup tab. The General Setup page appears. The FlexAddress
entry has a value of
Active or Not Active ; a value of active means that the
feature is installed on the chassis. A value of not active means that the
feature is not installed and not in use on the chassis.
To display a FlexAddress status overview for each server module:
1
Log in to the Web interface ("Accessing the CMC Web Interface" on
page 103).
2 Click Server Overview  Properties  WWN/MAC .
3 The FlexAddress Summary page is displayed. This page allows you to view
the WWN configuration and MAC addresses for all slots in the chassis.
The status page presents the following information:
4 For additional information, click Help .
Fabric
Configuration
Fabric A, Fabric B, and Fabric C display the type of the
Input/Output fabric installed.
iDRAC displays the server management MAC address.
NOTE: If Fabric A is enabled, unpopulated slots display chassis-
assigned MAC addresses for Fabric A and MAC or WWNs for
Fabrics B and C if they are in use by populated slots.
WWN/MAC
Addresses
Displays FlexAddress configuration for each slot in the chassis.
Information displayed includes:
• iDRAC management controller is not a fabric but its
FlexAddress is treated like one.
• Slot number and location
• FlexAddress active/not active status
•Fabric type
• Server-assigned and chassis-assigned WWN/MAC
addresses in use
A green check mark indicates the active address type, either
server-assigned or chassis-assigned.