User's Manual

198 Using the CMC Web Interface
5 To save the selections click the Save QuickDeploy Settings button. If you
made changes to the iDRAC network setting, click the
Apply iDRAC
Network Settings
button to deploy the settings to the iDRAC.
Starting iDRAC IPv4
Address (Slot 1)
Specifies the static IP address of the iDRAC of the server in
slot 1 of the enclosure. The IP address of each subsequent
iDRAC is incremented by 1 for each slot from slot 1's static
IP address. In the case where the IP address plus the slot
number is greater than the subnet mask, an error message is
displayed.
NOTE: The subnet mask and the gateway are not
incremented like the IP address.
For example, if the starting IP address is 192.168.0.250
and the subnet mask is 255.255.0.0 then the QuickDeploy
IP address for slot 15 is 192.168.0.265. If the subnet mask
were 255.255.255.0, the QuickDeploy IP address
range is not fully within QuickDeploy
Subnet error message is displayed when either the Save
QuickDeploy Settings or Auto-Populate Using
QuickDeploy Settings buttons are pressed.
iDRAC IPv4 Netmask Specifies the QuickDeploy subnet mask that is assigned to
all newly inserted servers.
iDRAC IPv4 Gateway Specifies the QuickDeploy default gateway that is assigned
to all iDRAC present in the chassis.
Enable iDRAC IPv6 Enables IPv6 addressing for each iDRAC present in the
chassis that is IPv6 capable.
Enable iDRAC IPv6
Autoconfiguration
Enables the iDRAC to obtain IPv6 settings (Address and
prefix length) from a DHCPv6 server and also enables
stateless address auto configuration. Default setting is
enabled.
iDRAC IPv6 Gateway Specifies the default IPv6 gateway to be assigned to the
iDRACs. Default setting is "::".
iDRAC IPv6 Prefix
Length
Specifies the prefix length to be assigned for the
IPv6 addresses on the iDRAC. Default setting is 64.
Table 5-57. QuickDeploy Settings
(continued)
Setting Description