Reference Guide

FirmwareVersion = 23.8.3-0027
DriverVersion = 06.802.11.00
RebuildRate = 30 %
BgiRate = 35 %
CheckConsistencyRate = 40 %
ReconstructRate = 30 %
PatrolReadRate = 30 %
PatrolReadMode = Manual
PatrolReadState = Stopped
CheckConsistencyMode = Stop On Error
LoadBalanceSetting = Disabled
CopybackMode = OFF
PreservedCache = Not Present
CacheMemorySize = 1024 MB
PersistHotspare = Disabled
SpindownUnconfiguredDrives = Disabled
SpindownHotspare = Disabled
Timeintervalforspindown = 30 (Minutes)
SecurityStatus = Unknown
EncryptionMode = None
SasAddress = 0x590B11C02620E600
PciDeviceId = 0x2f
PciSubdeviceId = 0x1f3e
PciVendorId = 0x1000
PciSubvendorId = 0x1028
PciBus = 0x0
PciDevice = 0x0
PciFunction = 0x0
BusWidth = Unknown
SlotLength = Short
SlotType = Unknown
CapableSpeeds = 6.0 Gb/s, 3.0 Gb/s
LearnMode = Not supported
HighAvailabilityMode = Fault Tolerant(Active/Passive)
PeerController = RAID.ChassisIntegrated.
1-1
hotspare
Description
Stops blinking or identifies an operation on the specified device.
Synopsis
racadm raid hotspare:<PD FQDD> -assign {yes | no} {type {ghs |
dhs}} {-vdkey:<VD FQDD>} {-current | -pending}
Input
• –current <optional>: Performs the configuration right now.
NOTE: If this requires the system to reboot it will reboot then.
• –pending: Save the configuration change for a later application. You can use a combination of
the –pending and –current flags on multiple commands to reduce the possible number of system
reboots.
• –assign {yes | no}: Assign or Unassign the physical disk drive as a hotspare.
• –type { ghs | dhs} : Assign as a global or dedicated hotspare.
• –vdkey: <VD FQDD>: Required for dedicated hotspare. Assign the dedicated hotspare to the
specified VD.
Example
racadm raid hotspare:Disk.Bay.0:Enclosure.Internal.
0-0:RAID.ChassisIntegrated.1-1 -assign no
73