White Papers
• Shut down the second port to learn the MAC address.
INTERFACE mode
station-move-violation shutdown-offending
• Shut down both the rst and second port to learn the MAC address.
INTERFACE mode
station-move-violation shutdown-both
• Display a list of all of the interfaces congured with MAC learning limit or station move violation.
CONFIGURATION mode
show mac learning-limit violate-action
Recovering from Learning Limit and Station Move Violations
After a learning-limit or station-move violation shuts down an interface, you must manually reset it.
To reset the learning limit, use the following commands.
NOTE: Alternatively, you can reset the interface by shutting it down using the shutdown command and then re-enabling it using
the no shutdown command.
• Reset interfaces in the ERR_Disabled state caused by a learning limit violation or station move violation.
EXEC Privilege mode
mac learning-limit reset
• Reset interfaces in the ERR_Disabled state caused by a learning limit violation.
EXEC Privilege mode
mac learning-limit reset learn-limit-violation [interface | all]
• Reset interfaces in the ERR_Disabled state caused by a station move violation.
EXEC Privilege mode
mac learning-limit reset station-move-violation [interface | all]
Disabling MAC Address Learning on the System
You can congure the system to not learn MAC addresses from LACP and LLDP BPDUs.
To disable source MAC address learning from LACP and LLDP BPDUs, follow this procedure:
• Disable source MAC address learning from LACP BPDUs.
CONFIGURATION mode
mac-address-table disable-learning lacp
• Disable source MAC address learning from LLDP BPDUs.
CONFIGURATION mode
mac-address-table disable-learning lldp
• Disable source MAC address learning from LACP and LLDP BPDUs.
CONFIGURATION mode
mac-address-table disable-learning
564
Layer 2