Reference Guide

• For a port extender (PE) Gigabit Ethernet interface, enter
the keyword peGigE then the peid/stack-unit/port-pipe
id information.
NOTE: The peGigE option is available only when the
extended bridge feature is enabled.
source-ip address Enter the keywords source-ip then the IP source address
in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP
destination address in IP address format.
source-port
number
Enter the keywords source-port then the source port
number. The range is from 1 to 65536. The default is None.
destination-port
number
Enter the keywords destination-port then the
destination port number. The range is from 1 to 65536. The
default is None.
source-mac
address
Enter the keywords source-mac then the MAC source
address in the nn:nn:nn:nn:nn:nn format.
destination-mac
address
Enter the keywords destination-mac then the MAC
destination address in the nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keywords vlan then the VLAN-id. The range is
from 0 to 4094.
ether-type Enter the keywords ether-type in the XX:XX format.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage Information
Because this command calculates based on a Layer 2 hash algorithm, use this
command to display flows for switched Layer 2 packets, not for routed packets
(use the show ip flow command to display routed packets).
The show port-channel-flow command returns the egress port identification
in a given port-channel if a valid flow is entered. A mismatched flow error occurs if
966
Interfaces